Aging refers to the use of high-temperature methods to apply environmental stress to the product, while environmental stress screening includes not only high-temperature stress, but also many other stresses, such as temperature cycling, random vibration, and other ways to test the power adapter.

Why electronic products must be 100 per cent aging test before leaving the factory;
Because in the processing of electronic products, due to the complexity of the process and the use of a large number of components and materials, will be introduced to a variety of defects (even if the design of the product is good). Both processing defects and component defects can be divided into obvious defects and potential defects. Obvious defects refer to those defects that cause the product not to work properly, such as short circuit / broken circuit. Potential defects lead to products that can be used temporarily, but in use the defects will be quickly exposed, the product can not work properly, for example, insufficient solder, the product can be used, but the slightest vibration may make the solder joints broken circuit. Obvious defects can be detected by conventional inspection means (i.e. ICT: In-Circuit Test, In-Circuit Test, is a standard test means for checking manufacturing defects and defective components by testing the electrical properties and electrical connections of in-line components (components on a manufactured board). It mainly checks the open and short-circuit conditions of individual components and circuit networks on the line, and has the characteristics of simple operation, quick and rapid, accurate fault location, FT, etc.) to be found. Potential defects can not be found with conventional inspection means, but the use of aging methods to eliminate. If the aging method is not good, it has not been eliminated potential defects will be zui finally in the product operation in the form of early failure (or failure) to show, which leads to product repair rate increases, maintenance costs.
Electronic products in the factory, to do 100 per cent of the aging test, then a large degree of reduction in the defective rate of the product.
In fact, the purpose of aging there is a more important purpose (and test the same): through the aging of the product processing technology to continue to improve the quality of components to continue to improve, improve the aging does not need to stop. Circuit boards in the aging must be tested, if a component is found in the test is often damaged, it means that the device has potential defects, the need to improve the quality of the supplier.
