I. Principle of operation
Variable voltage rectification:
Input AC power is first transformer step-down (e.g. 220V → 12V), and then converted into pulsating DC power by diode bridge rectifier circuit.
Filtering and smoothing:
The use of electrolytic capacitors to filter out high-frequency fluctuations, the output approximate DC waveform.
Linear voltage regulation:
Through the transistor or voltage regulator chip (such as LM317) dynamically adjust the resistance to heat at the expense of ‘cutting’ excess voltage, and ultimately output a stable DC.
Core structure
Module Function Typical device
Transformer Buck isolation Iron core transformer / toroidal transformer
Rectifier circuit AC to pulsating DC Diode bridge stack/rectifier bridge
Filter circuit Smooth waveform Electrolytic capacitor + inductor
Voltage regulator circuit Precise control of output voltage Voltage regulator chip/power transistor
Comparison of Advantages and Disadvantages
Advantages Disadvantages
Low noise (ripple <1mV) Low efficiency (30%-60%)
Fast response speed (μs level) Large size (need heat sink)
No high-frequency interference Serious heat generation
Simple circuit and easy to maintain Input voltage needs to be higher than the output
Typical Application Scenarios
Precision instruments: oscilloscope, medical equipment (need very low noise)
Audio equipment: Hi-Fi amplifier, studio mixer (to avoid high-frequency interference)
Laboratory power supply: adjustable voltage/current linear regulated power supply (0-30V continuous adjustment)
RF circuit: LDO (low dropout linear regulator) for RF module power supply
V. Difference with switching power supply
Parameter Linear power supply Switching power supply
Efficiency 30%-60% 70%-95
Operating frequency 50/60Hz (industrial frequency) 50kHz-2MHz (high frequency)
Ripple noise <1mV 10-100mV
Volume and weight Large (heat sink required) Small (high frequency transformer)
VI. Technology Evolution
Despite the obvious efficiency disadvantage, linear power supplies continue to be optimised in the following areas:
LDO (low dropout regulator): input and output voltage difference can be as low as 0.2V (3V traditionally required)
Parallel regulation: for ultra-low noise scenarios (e.g. powering quantum computing devices)
Hybrid design: front-stage switching power supply + back-stage linear regulator, combining efficiency and low noise
Summary: Linear power supply is still the first choice for high-precision electronic equipment due to its extremely low noise characteristics, but with the development of semiconductor technology such as GaN (gallium nitride), its application areas are gradually focusing on high-end scenarios such as ultra-precision instruments and scientific research equipment.